Concrete & Asphalt Anchor Kit For Mounting Sign Base

Concrete and Asphalt Anchors

Concrete and Asphalt Anchors Kit Include all of the following:

• 4 - 1/2" x 3" long concrete orange anchors
• 4 - 1/2" x 4" long -partial thread- lag screws
• 4 - Washers

Materials Needed for Installation:

• Drill with 5/8" (16mm) Bit
• Small Hammer
• 1/4"Allen Wrench
• One of the following: 3/4" (19mm) socket, 3/4" (19mm) wrench or adjustable wrench.

Installation Steps

1. Place Fixed Base on surface, align to desired position. Using the base as a template, mark the four (4) holes to establish pattern for drill.
2. Drill four (4) holes 3" (75mm) deep using a 5/8" (16mm) drill bit. Clean holes.
3. Using a small hammer gently tap the anchors into the holes.
4. Place base over the anchors. Put washer onto lag screw. Start lag screw through base hole into anchor. Use 3/4" wrench to tighten lag screw snug into base.
5. Place the sign or post into base, check for proper alignment and hand tighten all four socket cap screws. Use 1/4" Allen wrench to snug screws.