SNAP’n SAFE U-Channel Post Surface Mount Breakaway Base - Y3541, Sign Posts and Sign Stands

7″ Base For 2, 3, and 4 lbs./ft. U-Channel Posts
Material Sku Quantity/Price
1+
Cast Gray Iron Y3541-USMB $132.75
Special Freight Arrangement: Due to the size of this product, freight shipping will be required. You may contact our customer service team for a quote or you can place your order and a customer service representative will contact you about freight shipping charges. If you would like to use your own freight carrier, please include your freight carrier account in the special instructions box at the bottom of the checkout page before placing your order. A customer service representative will be in contact with you if there are any questions.

Phone: 800-274-6271
Fax: 800-279-6897
SafetySign.com guarantees that we have the lowest price on every item we manufacture, plain and simple.
If you find a lower price, we'll match it!
  • Details

SNAP'n SAFE™ U-Channel Post Surface Mount Breakaway

This SNAP'n SAFE™ Breakaway Device is made of cast gray iron, and withstands winds of 120 mph. Made from 80% recycled materials.

U-channel post ground mount snap'n safe breakaway system unit only U-channel post ground mount snap'n safe breakaway system on application

Installation

Installation instructions are included with every SNAP'n SAFE U-Channel post surface mount breakaway device. It is recommended that this breakaway be installed in concrete surfaces only due to the strength of concrete as compared to asphalt.

Tools required:

  1. ½″ socket and ratchet wrench
  2. 9/16″ socket and ratchet wrench

Installation instructions:

  1. Remove any burrs or imperfections from the 2 lbs./ft., 3 lbs./ft., or 4 lbs./ft. sign post.
  2. Check hole location of the sign post and anchor post. The bottom hole of the sign post must be ½″ on center (+/- ⅛″) from the end of the sign post.
  3. Determine the location for the surface mount coupler.
    (Please note that all bolts must be at least 5 inches from all concrete edges.)
  4. Place surface mount coupler on the concrete surface and place the sign post on top of the coupler. Using a level, determine if any washers are needed under the base at the hole location to level out the sign post.
  5. Using the surface mount coupler as a template, mark the location of the three (3) holes to drill. With a ⅜ inch drill bit, drill three (3) holes at least 4½″ deep. It is not necessary to blow the holes out or clean them out.
  6. Clean off concrete surface and align the coupler with the holes. Place any necessary washers under the base as determined in Step 4.
  7. Put one (1) washer on each bolt and install the three (3) bolts. (DO NOT tighten all the way until you are certain that the base is level and all three (3) hole locations are firmly resting on the washers or concrete.)
    Note: The bolts are carbon steel and are extremely hard. They have a 3,800 pound pull-out strength.
  8. Align the sign post to the SNAP'n SAFE coupler and attach using the (2) hex bolts, (2) nuts, and (2) washers.
    MAX TORQUE = 19 FT LBS.
SNAP'n SAFE U-Channel Post Breakaway Coupler diagram

Verified Secure | Customer Approved

Call Us 800-274-6271