Concrete & Asphalt Anchor Kit For Mounting Sign Base
For use with Fixed Base Y4946 and 78FLEXYPOST
- Item #:
- Y4949
Note:
Concrete and Asphalt Mounting Anchor Kit with 4" Lag Screws. For use with Fixed Base Y4946 and 78FLEXYPOST
Concrete or Asphalt mounting anchor kits secure fixed bases and flexible posts. These base mounting anchor kits include four 1/2 inch x 3 inch long concrete orange anchors, four 1/2 inch x 4 inch long partial thread lag screws, and four washers. Installation of concrete or asphalt mounting anchor kits is simple and offers superior resistance against pulling.
|
½ × 4″ Lag Screws + ½ × 3″ Concrete Anchors + ½″ Washers
|
|||
|---|---|---|---|
| Material | Sku | Quantity/Price | |
|
|||
| Zinc Plated Steel Lag Screws and Washers with Plastic Anchors | Y4949 | $12.35 | |
Special Freight Arrangement:
Due to the size of this product, freight shipping will be required. You may contact our customer service team for a quote or you can place your order and a customer service representative will contact you about freight shipping charges.
If you would like to use your own freight carrier, please include your freight carrier account in the special instructions box at the bottom of the checkout page before placing your order. A customer service representative will be in contact with you if there are any questions.
Phone: 800-274-6271
Fax: 800-279-6897
Phone: 800-274-6271
Fax: 800-279-6897
SafetySign.com guarantees that we have the lowest price on every item we manufacture, plain and simple.
If you find a lower price, we'll match it!
Recommended Accessories
- All
- Bases
- Post Bases
- Posts
- Stands
Replacement 8 x 8" Fixed Base
Y4946
78" Tall Impact Recovery Fixed Base Sign Post
78FLEXYB
10 lb. Portable Sign Stand with 8 lb. 4' U-Channel Post
Y3467
27 lb. Cast Iron Portable Sign Stand with 10 lb. 4' Post
W5430
2-3/8" Round Post Surface Mount Base
Y3544
U-Channel Post Surface Mount Base
Y3545
Square Post Surface Mount Base
Y3546
CONCRETE AND ASPHALT ANCHORS
- Concrete and Asphalt Anchors Kit Include all of the following:
4 - 1/2" x 3" long concrete orange anchors
4 - 1/2" x 4" long -partial thread- lag screws
4 - Washers
Materials Needed for Installation
- Drill with 5/8" (16mm) Bit
- Small Hammer
- 1/4"Allen Wrench
- One of the following: 3/4" (19mm) socket, 3/4" (19mm) wrench or adjustable wrench.
Installation Steps
- Place Fixed Base on surface, align to desired position. Using the base as a template, mark the four (4) holes to establish pattern for drill.
- Drill four (4) holes 3" (75mm) deep using a 5/8" (16mm) drill bit. Clean holes.
- Using a small hammer gently tap the anchors into the holes.
- Place base over the anchors. Put washer onto lag screw. Start lag screw through base hole into anchor. Use 3/4" wrench to tighten lag screw snug into base.
- Place the sign or post into base, check for proper alignment and hand tighten all four socket cap screws. Use 1/4" Allen wrench to snug screws.
