Stainless Steel Strapping - Y3534, Sign Mounting Hardware

Stainless Steel Strapping

Stainless steel strapping is ideal for installing signs on large diameter posts and poles when standard sign mounting brackets won't work.

Flared leg bracket with ¾" S.S. strapping

Straight leg bracket with ¾" S.S. strapping

Side view of a mounted sign using S.S. strapping

Front view of a mounted sign using S.S. strapping

Tools required for installation:

1. Strapping tool with cutter such as our RTST-1, Y3532, or Y3533
2. 2 Flared or Straight Leg sign mounting brackets
3. Hammer

Installation steps:

1. Measure out enough stainless-steel strapping to go around the pole including an extra 12″ or so of slack.
2. Insert one end of the strapping into your straight or flared leg sign mounting bracket.
3. Insert the same end into your buckle or wing seal and bend about 2″ to 3″ of strapping underneath the wing seal or buckle.
4. Wrap the strapping around the pole and slide the other end of the strapping through the buckle or wing seal and bend it back so that the strapping stays in place.
5. Tighten the strapping down with the strapping tool, making sure that the tool is against the wing seal or buckle during this step.
6. Once the strapping is tight, bend the strapping with the tool to hold the tension and use the cutter to cut off the excess strapping.
7. Fold the excess strapping over the buckle or wing seal and hammer down the wings to secure the strapping
8. Repeat these steps to install the second band of strapping.
9. At last, proceed to install the sign onto the brackets, using the hardware provided (1 hex head bolt and 1 washer each)

Strapping being inserted into the buckle	Strapping being inserted into wing seal	The other end of the strapping being inserted and bent to hold it in place
Strapping tool Y3532 tightening the strapping around the pole	Same process with a different tool Y3533 tightening the strapping around the pole	Using either the Spinner or Ratchet tool cut the excess strapping
Extra strapping left over to be sealed under buckle or wing seal	Bend the strapping over the buckle or wing seal to partially secure the strapping	Wing seal or buckle being closed to secure the strapping
Photo of mounted sign bracket	Sign installation process	Photo of a mounted sign