One-Handed Ratchet Tool with Cutter
The One-Handed Ratchet Tool For Stainless Steel Strapping provides an effortless way to install banding around poles and pipes. This tool accepts strap widths of 1/4" to 3/4", strap thicknesses of 0.015" to .030", weighs 2.9 lbs., and includes a cutter.
For ¼″ x .015″ – ¾″ x .030″ Strapping
|
|||
---|---|---|---|
Material | Sku | Quantity/Price | |
|
|||
Steel with Vinyl Coated Handle | Y3533 | $209.95 |
Special Freight Arrangement:
Due to the size of this product, freight shipping will be required. You may contact our customer service team for a quote or you can place your order and a customer service representative will contact you about freight shipping charges.
If you would like to use your own freight carrier, please include your freight carrier account in the special instructions box at the bottom of the checkout page before placing your order. A customer service representative will be in contact with you if there are any questions.
Phone: 800-274-6271
Fax: 800-279-6897
Phone: 800-274-6271
Fax: 800-279-6897
SafetySign.com guarantees that we have the lowest price on every item we manufacture, plain and simple.
If you find a lower price, we'll match it!
Recommended Accessories
- All
- Brackets
- Buckles
- Strapping
- Wing Seals
One-Handed Ratchet Tool with Cutter
The one-handed ratchet tool for stainless steel strapping provides a quick and easy way to install banding around poles and pipes. Use with ¼″ to ¾″ wide strapping.
![]() |
![]() |
Installation
- Measure out enough stainless-steel strapping to go around the pole including an extra 12″ or so of slack.
- Insert one end of the strapping into your straight leg sign mounting bracket.
- Insert the same end into your buckle or wing seal and bend about 2″ to 3″ of strapping underneath the wing seal or buckle.
- Wrap the strapping around the pole and slide the other end of the strapping through the buckle or wing seal and bend it back so that the strapping stays in place.
- Tighten the strapping down with the strapping tool, making sure that the tool is against the wing seal or buckle during this step.
- Once the strapping is tight, bend the strapping with the tool to hold the tension and use the cutter to cut off the excess strapping.
- Fold the excess strapping over the buckle or wing seal and hammer down the wings to secure the strapping
- Repeat these steps to install the second band of strapping.
![]()
Strapping being inserted |
![]()
Strapping being inserted |
![]()
The other end of the strapping |
![]() Strapping tool Y3533 tightening and then cutting the strapping around the pole |
![]() Using the Ratchet tool cut the excess strapping |
![]() Bend the strapping over the buckle or wing seal to partially secure the strapping |